Disconnect the battery wait 30 seconds then reconnect the battery.
Delta touch faucet troubleshooting manual.
Make sure the touch is not too long or too short it should be deliberate like striking a key on a piano.
Delta dryden 4551 series installation manual 8 pages.
As with any technology issues can arise.
Disconnect the solenoid from the battery pack and wait for at least 30 seconds for the solenoid to be reset.
Sign in or register now.
A simple touch anywhere on the spout or kitchen faucet handle with your wrist or forearm activates the flow of water at the temperature where your faucet handle is set.
If none of the touch areas respond to touch activation.
If faucet operates normallyreplace led base.
Once you remove the handle you will see the bonnet.
This way you will have water however the touch problem might still persist.
Sometimes your hands could use a hand whether you have two full hands or 10 messy fingers delta touch 2 o technology helps keep your faucet clean even when your hands aren t.
If metal or granite sink confirm faucet shank is not touching inside edge of sink hole and is clear ofsink by min.
Once you have access to the cartridge simply pull it straight out and replace.
It could also be that the user is not touching the faucet properly.
Don t use fingernails or a dry cloth to touch the faucet.
What to do if your led indicator isn t working what to do if your led indicator is flashing red how to disable touch activation what to do if your touch2o faucet is turning on and off by itself.
Make sure you use plumber s grease on all parts that get reinstalled.
Installation support and repair part information for delta faucet 9192t sd dst single handle pull down kitchen faucet with touch 2 o technology and soap dispenser you have saved items.
Finally the unit may need to reset.
Of separate led sensor and battery wires by minimum of 2 confirm led wire is not pinched and is fully plugged in unplug the led wire and try to operate faucet.
Delta two handle mini widespread lavatory faucet installation guide.
Disconnect your terminal from the batteries and make sure that your solenoid valve is connected properly.