Use either an allen wrench or phillips screwdriver to remove the screw holding the faucet handle in place.
Delta tub faucet leaking at base.
This tutorial is intended to guide a person through the steps of repairing a faucet that drips when turned off or leaks through the base of the faucet this tutorial applies to standard delta faucets as well as the pull out model pictured above.
Then remove the faucet handle body and set it aside.
Unscrew the stem unit nut with channel locks.
Consumer safety is our number one concern.
Use channel lock pliers in quick short bursts to break the seal.
Just don t exert too much pressure or it will bend.
Test to see if water is leaking around the flange by plugging your drain with a rubber stopper.
Turn off the water in the house by closing the main water valve.
You have saved items.
Remove the tub spout and replace it with a genuine delta tub spout.
Lift the stopper out.
How to repair a leaking delta tub spout step 1.
Replace seats and springs 3 in diagram repair part rp4993.
How to fix a leaky delta faucet.
Reattach the nut that holds the horizontal rod to the pop up body.
Unscrew the delta faucet handle by hand and use an allen wrench to loosen the set screw that holds the handle body in place.
For faucets purchased prior to 2007 please order rp1050 cap and rp61 cam and packing.
Turn on another faucet at a lower level to.
And take a picture of the stem unit before you remove it with the channel locks.
To locate a local source for delta tub spouts contact licensed professional plumbing contractor or delta showroom or call 1 800 345 delta 3358 or e mail us for assistance.
When troubleshooting a leaking faucet choose your delta faucet type identify your leak location in the diagram and review the associated solutions and recommended replacement parts.
Do not cover the outside of the.
Remove the nut that holds the horizontal rod to the body of the pop up stopper.
Remove the round metal stem and pull out the ball and cam and packing.
If the faucet is leaking from under the handle replacing the cam and packing should solve the problem.