Garden answer youtube.
Diy gutter planter.
The front and back of each gutter piece will have 2 holes.
This will lock each segment along the suspension wire.
Then thread the brace piece through the same clamp and tighten it with a screwdriver.
Garden answer youtube.
Start by drilling the bottom holes using your drill and 3 8inch bit.
Tie a knot at one end of the 10 foot rope.
10 ft vinyl gutter but i only used about 6 feet of it 3 sets vinyl gutter end caps 1 4 inch natural fiber rope it comes in 50 feet rolls which is plenty home depot pdf instructions.
Measure 12 inches of.
Repeat threading up through the bottom hole and out through the side hole on the next two left gutter sections.