Diy How To Make Siding Mounting Blocks

Hold the block up against the siding s lower or butt edge and using.

Diy how to make siding mounting blocks.

1 x 2 furring strip. I had it lying around and decided to make a mounting block. Or mount it to a stud. 1 x 6 pine boards.

Use a jigsaw to cut a hole in the block to fit around the outlet box. Not a lot really. And like i said all of this wood was scrap. To install the kit insert the cable connector in an opening in the center of the mounting block then feed in the cable s from the back.

I like to size my blocks so that the top and bottom edges line up with full courses of siding because it looks better. To make a mounting block like this you will need a few things. Drill and countersink pilot holes for screws in two opposite corners. The block should be rectangular and large enough to accommodate the base of the fixture.

Siding mounting blocks ply gem mounts and blocks create a smooth stable surface for installing accessories on your home from lights and doorbells to electrical outlets water faucets and more. Connect the wires mount the fixture and caulk around the block so it s watertight. 2 x 4 pine boards. Cut a mounting block out of 1 inch lumber to mount a fixture on vinyl or clapboard siding.

Diy projects ideas. Get free shipping on qualified mounting blocks or buy online pick up in store today in the building materials department. 18 volt drill with screw head attachment.