Do Wood Floors Have To Be Refinished After Stripping

Staining floors especially for first time do it yourselfers is a tricky business.

Do wood floors have to be refinished after stripping.

Here are four big reasons why. Asked this on the flooring forum but not much traffic there these days. Remove the stripper from the wood. Hit the area with a putty knife to scrape off the stripper along with the finish.

The contractor will sand the old finish off the floors repair any damaged areas and ensure all wood dust is cleared from the floors. Use a stiff paint brush to spread the stripper over a surface of the wood in a thick even layer. Stain is often applied in two coats and can create a strong odor. See above for full cure times of our most frequently used wood flooring finishes.

Your floors are begging you for your help. Although it gets most of the varnish off the furniture there will be some sanding required after the old finish is removed. 24 hours after floors have been sanded and finished they can be swept with a soft bristle broom only. When they polyurethane wears off the wood absorbs the water.

The equipment used in refinishing floors is noisy. Choose the best varnish stripper for your needs. You can do this in two steps. Refinishing is an easy low cost way to bring out natural beauty in wood furniture and make fine details shine.

No vacuums until floors have fully cured. And when it does go wrong the only solution is to re sand the floor and start all over from the beginning. Apply enough stripper to keep the surface wet and never work in direct sunlight as you can dry the wood. That s why we do our utmost to talk you out of staining your wood floors.

We re getting ready to finish our wood floors some new and some refinish. We re doing the entire first floor in two phases due to lack of space to put things it s two phases of sand stain and 3 coats of poly. Stain makes sander scratch shockingly visible. Leaving spots will yield an uneven surface when you finally start finishing it.

The job begins after the room is fully cleared. Do not put too much denatured alcohol in the pan as it does tend to quickly evaporate. When you have determined that you do need to strip a piece always remove all the old finish or paint thoroughly. That water can come from rain snow pet s paws spilled drink or even just cleaning product through normal maintenance.

Use denatured alcohol in a disposable aluminum pan to clean off the remaining stripper with the help of steel wool. You can paint with pure freedom even using a paint sprayer and spillages rarely cause much damage. Do not use any liquids at all for cleaning any newly refinished hardwood floors until they are fully cured. Chemical stripping products come in a liquid spray or gel form.